HARLEY DAVIDSON BILLET CLOCK, FRONT BRAKE MASTER CYLINDER MOUNT INSTALLATION MANUAL

download
INSTALLATION 1. See Figure 1. Clean the face of the front master cylinder reservoir with denatured alcohol and a paper towel. 2. Remove the paper backing from the adhesive strip, and line the clock up squarely to the master cylinder reservoir as shown. Press firmly into place and hold for a few seconds. 3. Let the adhesive set for a while before setting the time. SETTING THE TIME ON THE CLOCK 1. Using the hex key included in the kit, remove the two screws securing the faceplate to the clock housing 2. Lift off the faceplate and “O”-ring, and set aside. Lift the clock face and movement assembly out of the housing. 3. Pull out the stem carefully, and turn it until the hands indicate the correct time. Carefully push the stem back in to start the clock. 4. Check that the “O”-ring is in place in the faceplate, and re-install the faceplate to the clock housing. Do not over- tighten. REPLACING THE CLOCK BATTERY The clock battery (Type SR626SW) is a common type, available wherever watch batteries are sold. When storing the motorcycle for a long period, pull out the stem carefully to stop the clock and save battery life

Incoming search terms:

• 2011 hayabusa clock
• 2014 1900 yamaha stratoliner clock setting
• harley davidson brake masters cylinder clock
• how to set the time on a stratoliner
• set clock on honda vfr 1200
• YAMAHA TIME ADJUSTMENT